Program
P0
P1 P2 P3 P4 P5 P7 P8 P9
11
1–2: OSC Basic
The multisample(s) (waveform) or drum kit on which the
program will be based can be selected here for oscillator 1
and/or oscillator 2.
Internal ROM contains 962 preset multisamples and 153
drum kits. By selecting a RAM multisample, you can use a
multisample that you created in Sampling mode or that you
loaded in Media mode.
The following illustration shows a LCD screen where
“Oscillator Mode” (1–1a) has been set to Double. If this is
set to Single, the OSC2 Multisample (1–2b) will not appear
and cannot be set.
The following illustration shows the display when “Oscilla-
tor Mode” (1–1a) has been set to Drums.
1–2a: OSC1 Multisample
Here you can select a multisample.
You can select different multisamples for High and Low, and
use velocity to switch between the two multisamples. Start
Offset, Reverse, and Level can be adjusted independently
for the High and Low multisamples.
High:
High MS Bank [ROM, RAM, Piano...Synth]
High Multisample [Refer to table]
Specifies the bank and multisample number of the High
multisample. The multisample you select here will sounded
by velocities greater than the value of the “Velocity M.Sam-
ple SW Lo→Hi” (1–2c) parameter “OSC1.” If you don’t
want to switch samples by velocity, set the “OSC1” value to
001 and specify only the High multisample.
* All of these are preset multisamples except for MS Bank: RAM.
* OrchS and B are taken from “Peter Siedlaczek’s Advanced Orches-
tra” from Best Service Corporation.
Each multisample has an upper limit, and may not pro-
duce sound when played above that limit.
When you press the “High Multisample” popup button, a
multisample list will appear, allowing you to select a multi-
sample from the list.
If ROM is selected as the “High MS Bank,” you can select a
multisample from a tabbed list organized by type of instru-
ment.
Category/ROM Multisample Select menu:
S.Offset (High Start Offset) [Off, On]
This specifies the point at which the multisample will begin
sounding. For some multisamples this parameter will have
no effect.
On (checked): The sound will start from the start offset loca-
tion that is pre-determined for each multisample.
However when a RAM bank is selected, this will depend on
the selected multisample. If you select a multisample that
includes one of the following types of sample, checking this
item will cause playback to start from the Loop Start
Address.
•A RAM sample that was recorded (sampled) in
Sampling mode etc.
•A sample whose Loop Start Address was edited in
Sampling mode after the sample was loaded in Media
mode
•A sample whose Loop Start Address was specified
automatically when it was loaded as an AKAI, AIFF, or
WAVE file in Media mode
Off (unchecked): The sound will start from the beginning of
the multisample waveform.
Rev (High Reverse) [Off, On]
The multisample will be played in reverse. This makes the
1–2
1–2b
1–2c
1–2a
1–2
1–2d
MS Bank Mbyte No. Explanation
ROM 32 000–424 TRITON Classic preset multisamples
RAM 96 000–999 RAM multisamples (created in Sam-
pling mode or loaded in Media mode)
Piano 16 000–003 Preset multisamples for stereo piano
New1 16 000–007 Preset multisamples for stereo piano
and choir
New2 16 000–048 Preset multisamples for organ, solo
brass, electric guitar, acoustic guitar,
electric bass, acoustic bass, etc.
Best 16 000–046 Preset multisamples for electric piano,
clavi, brass, woodwinds, choir, drums,
etc.
OrchS 16 000–112 Preset multisamples for orchestral
strings
OrchB 16 000–079 Preset multisamples for orchestral
brass, woodwinds, percussion, and
harp etc.
Vint 16 000–157 Preset multisamples for vintage analog
synths
Synth 16 000–077 Preset multisamples for house and
trance music
To Next Page
Loading...
