Appendices
323
• 88 key model
Using a screwdriver, remove four screws from the EXB-
MOSS cover, and lift up the cover.
6 Verify the installation location.
7 Remove the EXB-MOSS from its packing pouch.
8 Note that screws and washers are attached to the four
corners of the board.
9 Use the four screws to attach the EXB-MOSS to the corre-
sponding brackets inside the TRITON Extreme.
Before the screws are tightened, the EXB-MOSS will
float slightly above the brackets. If at this time you
apply excessive force to the EXB-MOSS, the screws or
washers may come out.
0 Plug the cable into the connector as shown in the dia-
gram. Press the cable firmly in until it stops.
Do not touch any part of the circuit board other than
the connector in which the cable is being inserted.
A Reversing the procedure by which you removed the
EXB-MOSS cover, reattach the cover.
B When all steps have been completed, turn on the power
and make sure that the EXB-MOSS has been installed
correctly. (“Checking after installation” ☞p.320)
C After you have verified that the EXB-MOSS was
installed correctly, use Global P0: “Load Preset/Demo
Data” to load the EXB-MOSS demo data. (☞OG p.128)
With the cover removed
EXB-MOSS
EXB-MOSS
connector
Calendar battery
holder
Rear panel
Screw
Washer
Screw
Washer
Chassis to which the board is
being installed
EXB-MOSS
Connector
Press in all the way Connector
Rear panel
To Next Page
Loading...
