KOSTAD CPC 50 - Page 2

To Next Page

To Previous Page

Legal notice

Warning notice concept

This manual contains information that you must observe for your personal safety and to avoid damage to property. The

instructions for your personal safety are highlighted by a warning triangle, instructions for property damage alone are

without a warning triangle. Depending on the hazard level, the warnings are shown in decreasing order as follows.

If several hazard levels occur, the warning for the highest level is always used. If the warning triangle is used in a warning

against personal injury, a warning against damage to property may also be added to the same warning.

Qualified staff

The product/system associated with this documentation may only be handled by personnel qualified for the respective task

and in compliance with the associated documentation for the respective task, in particular the safety and warning

instructions contained therein. Due to their training and experience, qualified personnel are able to recognise risks and avoid

possible hazards when handling these products/systems.

Intended use of Kostad products

Note the following:

Brands

All designations marked with ® are registered trademarks of Siemens AG. The other designations in this document may be

trademarks whose use by third parties for their own purposes may infringe the rights of the owner.

Disclaimer

We have checked the contents of this publication for conformity with the hardware and software described. Nevertheless,

deviations cannot be ruled out, so that we cannot guarantee complete conformity. The information in this publication is

checked regularly and any necessary corrections are included in subsequent editions.

Kostad Steuerungsbau GmbH

Parkallee 20

2483 Ebreichsdorf

Austria

rights reserved.

DANGER

means that death or serious bodily injury will occur if the appropriate precautions are not taken.

WARNING

means that death or serious bodily injury may occur if the appropriate precautions are not taken.

CAUTION

means that slight bodily injury may occur if the appropriate precautions are not taken.

ATTENTION

means that property damage can occur if the appropriate precautions are not taken.

WARNING

Siemens products may only be used for the applications specified in the catalogue and in the associated technical

documentation. If third-party products and components are used, they must be recommended or approved by Siemens.

Faultless and safe operation of the products requires proper transport, storage, assembly, installation, commissioning,

operation and maintenance. The permissible ambient conditions must be observed. The instructions in the relevant

documentation must be observed.