Page 17
7.4 KOZI Pellet Insert Removal
There may be some situations where the KOZI pellet insert needs to be removed from
the fireplace; venting may need to be resealed, regular maintenance performed, etc....
Removal of the KOZI pellet insert heater from a fireplace is the reverse of installation
with the following exceptions: make sure the insert is not operating, has had sufficient
time to cool down and that power to the insert has been removed. Now you can pull the
insert all the way out and do the maintenance on the insert or fireplace.
7.5 Operation and Maintenance
Please refer to the “Heater Operation” section of this manual for complete instructions on
how to operate your KOZI pellet insert. Please note that fuel loading on the insert is
done through the small opening on the top of the stove. To load fuel into the insert,
remove the cover plate from the top of the insert, pour fuel into the opening and replace
the cover plate. DO NOT place hands inside the opening to the hopper. There are
moving parts in the hopper which can cause bodily harm.
Maintaining the KOZI pellet insert is the same as maintaining a free standing pellet
stove. Please read the “Maintenance” section for instructions on cleaning your insert,
venting and other maintenance precautions.
8. Mobile Home Additional Installation Requirements
8.1 Typical Mobile Home Installation Configuration
The following figures describe some typical installations for mobile homes. Variations of
these are possible. Common sense, safety and compliance with local building codes must
be respected in any variation.
Figure 15A. Mobile home installation
through wall; interior rise
Figure 15B. Mobile home installation
through wall; exterior rise
To Next Page
Loading...
