Page 8
1.2 Other Clearances and Recommendations
1. This heater must be mounted on a noncombustible material, placed
underneath the heater and extending a minimum of 6 inches (150 mm) in
front and beyond each side of the fuel loading and ash removal openings
of the heater.
2. Clearances can ONLY be reduced by means approved by local building or
fire officials in your area.
3. A safety certification label has been attached to either the back of the
heater or on top of the hopper (inserts). A sample label is shown here to
help you locate this label on your heater. Please read all information on
your heater’s label. All information on the certification label supersedes
any information contained in this manual.
Figure 5 Certification Label
To Next Page
Loading...
