Need help?Do you have a question about the Kracht VC PULSE Series and is the answer not in the manual?
Details the purpose and scope of the operating instructions for the device.
Provides the contact details and address of the manufacturer, KRACHT GmbH.
Lists other relevant documents to observe in addition to these instructions.
Defines DANGER, WARNING, CAUTION, ATTENTION, NOTICE, and TIPP symbols for hazard communication.
Specifies the approved applications and operational conditions for the device.
Outlines the necessary qualifications and training for personnel handling the device.
Provides fundamental safety guidelines for operation and maintenance.
Details critical hazards including hazardous fluids, rotating parts, and electrical components.
Explains the operational mechanism of the device based on gear motor principles.
Illustrates the physical layout and identifies key components of the device.
Details the coding system used to specify product variations and options.
Provides an overview of key technical parameters like design, pressure, and fluid properties.
Lists nominal sizes and their corresponding measuring ranges for various bearing types.
Details the available connection types (pipe and plate) for different nominal sizes.
Presents graphical data showing flow resistance for ball bearing models.
Presents graphical data showing flow resistance for plain bearing models.
Specifies maximum allowable operating pressure and sound pressure levels.
Defines the acceptable fluid and ambient temperature limits for device operation.
Lists the materials used for seals, housing, measuring unit, and bearings.
Provides the weight of the device for different configurations.
Shows technical drawings with precise dimensions and mounting details of the device.
Instructions for checking the device for transport damage upon receipt.
Provides general advice on storing the device to maintain its integrity.
Specifies optimal temperature, humidity, and protection measures for storage.
Critical safety information regarding explosion protection during installation.
Guides the user through the physical mounting and connection of the device.
Details pre-installation checks for damage, contamination, and environmental conditions.
Instructions for connecting the device using a plate interface.
Instructions for connecting the device using a pipe interface.
Procedures for aligning and replacing the rotary encoder.
Information on wiring, signal outputs, and protection classes for electrical connections.
Essential safety precautions to be followed before and during device start-up.
Steps required before starting the device, including filling with media.
Details the connector pin assignments and signal line requirements.
Steps for gradual pressurization, venting, and final operational checks.
Safety guidelines to be observed when removing the device from the system.
Step-by-step instructions for safely dismantling and removing the device.
Critical safety measures to be taken before and during maintenance activities.
General advice on performing maintenance, including documentation and parts replacement.
Procedure for cleaning the device and removing any deposits.
Provides recommendations and guidelines for performing maintenance work.
A table outlining recommended maintenance tasks and their frequencies.
Details on performing various inspections related to device performance and condition.
Procedures for inspecting components and replacing seals and cleaning deposits.
Essential safety measures to be followed during repair activities.
Overview of the repair process, including troubleshooting and manufacturer repairs.
Guidance on identifying faults and implementing corrective measures for the device.
General| Brand | Kracht |
|---|---|
| Model | VC PULSE Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
