6.2 Operating the 840Hxl Using the Control Application
The 840Hxl Control Application is a PC-based program which lets you program
and control the device.
To use the 840Hxl Control Application you must download and install the USB
driver and the 840Hxl Control Application.
Note: The USB driver is not supported by Windows 64 bit systems.
6.2.1 Downloading and Installing the USB Driver and Control
Application
To install the USB driver and Control Application:
1. Navigate to the Kramer Electronics Web site
(http://www.kramerelectronics.com) and search for the product 840Hxl.
2. Click on the Downloads tab.
3. Download the 840Hxl Windows USB Driver.
4. Download the 840Hxl Control Application to a designated folder on your
computer.
5. Extract the compressed USB driver file to your designated folder.
Two files are extracted, a .inf and a .sys file.
6. Connect the USB cable between your computer and the 840Hxl.
7. Connect the power supply to the 840Hxl.
8. After a few seconds the Found New Hardware message appears as shown
in Figure 4.
To Next Page
Loading...