Kramer PT-871xr

Kramer Electronics Ltd.
PT-871/2-KIT, PT-871/2xr-KIT, WP-871xr, WP-872xr, PT-871xr, PT-872xr – Installing Device
7
Installing Device
This section provides instructions for installing PT-871/2-KIT, PT-871/2xr-KIT, WP-871xr,
WP-872xr, PT-871xr, PT-872xr.
Before installing the device, verify that the environment is within the recommended range:
• Operation temperature – 0 to 40C (32 to 104F).
• Storage temperature – -40 to +70C (-40 to +158F).
• Humidity – 10% to 90%, RHL non-condensing.
When installing on a 19" rack, avoid hazards by taking care that:
• It is located within recommended environmental conditions. Operating
ambient temperature of a closed or multi-unit rack assembly may exceed
ambient room temperature.
• There is enough air flow around the device.
• The device is placed upright in the correct horizontal position.
To mount PT-871/2-KIT, PT-871/2xr-KIT, PT-871xr and PT-872xr:
• Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/downloads/PT-871/2-KIT.
• Fasten a bracket (included) on each side of the unit and attach it
to a flat surface.
For more information go to
www.kramerav.com/downloads/PT-871/2-KIT.
• Attach the rubber feet and place the unit on a flat surface.