SID-X3N - Operating the SID-X3N
7.2 Taking Control of the Switcher Input When Connected
to the VS-62H
To activate the input of the VS-62H to which the SID-X3N is connected, press the
STEP-IN button. If the VS-62H grants the SID-X3N access to the input, the STEP-
IN button lights. If the VS-62H does not grant access for some reason, the button
flashes for a few seconds and then does not light. This may be because the
VS-62H input connected to the SID-X3N has been set to have a lower priority than
the currently active input.
Note: Input priority on the VS-62H is set using the Kramer Control Software.
7.3 Locking the EDID
The currently stored EDID can be locked to prevent it from being overwritten. To
lock the current EDID, set DIP-switch 5 to ON (see Section 8).
Note: The device must be power-cycled after you change this DIP-switch.
7.4 Audio Mode Selection
Option DIP-switches 2 and 3 control the manner in which audio is handled (see
Section 8).
7.5 Adjusting the UXGA Input Phase
Adjust the phase to get a clean, sharp picture on the screen, with minimal
horizontal streaking and shimmering.
To adjust the UXGA input phase:
Press and hold the Input Select button to increase the phase repetitively by
one degree per second
Press and hold the StepIn button to decrease the phase repetitively by one
degree per second
To Next Page
Loading...
