Kramer SID-X3N - Configuring the SID-X3 N; Setting the Configuration DIP-Switch; Figure 8: the Configuration DIP-Switch

16
SID-X3N - Configuring the SID-X3N
8 Configuring the SID-X3N
8.1 Setting the Configuration DIP-switch
The 8x dip-switch provides the ability to configure a number of device functions. A
switch that is down is on, a switch that is up is off. By default, switch 2 is down
(on), all the other switches are up (off).
Figure 8: The Configuration DIP-switch
Note: You must power cycle the device if you make any changes to the
DIP-switch.
#
Feature
Function
DIP-switch
1
Program
Enables firmware updates
On—Enable updating
Off—Disable updating
2
General Audio
Control
Selects whether the analog
audio is embedded in the
outputs, (see Section 6.2)
On—Use embedded audio for
HDMI and DP; the audio selection
for DVI is selected by DIP-switch 3
Off—The HDMI, DVI and DP
inputs use the analog audio signal
if a 3.5mm audio jack is inserted
into the analog audio input. If no
jack is inserted, they use their
embedded audio signals
3
DVI Audio
Control
(active only
when DIP-
switch 2 is on)
Selects whether the analog
audio is embedded in the DVI
signal
On—When switch #2 is on, the
analog audio signal is used with
the DVI input
Off—When switch #2 is off, the
embedded audio signal is used in
the DVI input
4
Video Mode
Input Selection
Sets the video input selection
mode to either last connected or
manual
On—Last connected
Off—Manual
5
Lock EDID
Locks the current EDID, (see
Section 7.3)
On—Locked EDID
Off—Automatic EDID selection