Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 2
2.3 Shielded Twisted Pair/Unshielded Twisted Pair 3
2.4 Recycling Kramer Products 3
3 Overview 4
4 Defining the SID-X3N Step-in Commander 6
5 Connecting the SID-X3N 8
5.1 Connecting the Remote Step-In Switch and LED 9
5.2 Connecting the Remote Select Switch and LED 10
5.3 Connecting the Remote Input Selection LEDs 11
6 Principles of Operation 12
6.1 Video Input Selection 12
6.2 Audio Signal Control 13
6.3 Automatic Output Shutdown 13
7 Operating the SID-X3N 14
7.1 Manually Selecting an Input 14
7.2 Taking Control of the Switcher Input When Connected to the VS-62H 15
7.3 Locking the EDID 15
7.4 Audio Mode Selection 15
7.5 Adjusting the UXGA Input Phase 15
8 Configuring the SID-X3N 16
8.1 Setting the Configuration DIP-switch 16
9 Technical Specifications 18
9.1 Supported Resolutions 19
10 Default EDID 21
10.1 HDMI, DisplayPort and DVI 21
10.2 PC-UXGA 23
11 Protocol 2000 25
11.1 Syntax 25
11.2 Instruction Codes 26
12 Protocol 3000 28
12.1 Kramer Protocol 3000 Syntax 28
12.2 Kramer Protocol 3000 Commands 31
Figures
Figure 1: SID-X3N Step-in Commander Front Panel 6
Figure 2: SID-X3N Step-in Commander Rear Panel 7
Figure 3: Connecting the SID-X3N Step-in Commander 8
Figure 4: Remote Step-In Switch and LED Wiring 9
Figure 5: Remote Select Switch and LED Wiring 10
Figure 6: Remote Input Indicator LED Connections 11
Figure 7: Remote Input Indicator LED Wiring 11
Figure 8: The Configuration DIP-switch 16
To Next Page
Loading...
Need help?
General
