4. Configure the commands as follows:
▪ Enter a device command (for example, turn projector off).
▪ Enter the command description.
▪ Select a trigger from the drop-down box to carry out the command (5V On, 5V Off,
Sync/Clock or No Sync/No Clock).
▪ Enter a delay time, if required.
▪ Check Hex to view the Hex format, if required.
▪ Check enable to enable the command.
Figure 30: RS-232 – Creating a Command
5. Click Add.
Figure 31: RS-232 Page – Command Added
6. Optionally, perform the following for the command:
▪ Click Delete to delete the command.
▪ Click Test to test the command.
▪ Change any of the command configurations.
▪ Enable or disable the command.
To Next Page
Loading...
