Setting the Volume
To set the mic and output volumes:
1. In the Navigation pane, click Input Select. The Input Select page appears
(see Figure 16).
2. Use the Volume sliders to adjust:
▪ MIC 1 /MIC 2 microphone volume.
▪ Line (the selected input) volume.
▪ Output (LINE OUT and S/PDIF OUT ) volume.
▪ Speaker volume.
You can also set a specific volume by entering the volume value in the text box above a
slider and pressing Enter on your PC.
3. Click the Mute icon to mute line / speaker audio signal.
Setting Device Parameters
The Device Settings page shows the model name, its serial number and MAC address as
well as its current firmware version.
The Device Settings page enables performing the following functions:
• Updating the Firmware on page 28.
• Changing Ethernet Settings on page 29.
• Soft Factory Reset on page 30.
To Next Page
Loading...
