Start-Up Screen
Homing Instructions
Every time the control power is turned on, this screen comes up. Have the auto/manual switch in “AUTO”
and press the “RESET” button on the front of the starter box that is located on the right side of the machine.
Press “ENT” on the keypad and the measuring bend roll will automatically home itself. The main operation
screen will then appear. When the bend roll is at home position the readout POS on the main screen
should be 000 counts within a few numbers
KRB Machinery Company
WARNING
UNIT MUST BE HOMED PRIOR TO USE
PRESS <ENT> KEY TO HOME
Ver. 09. 25. 01
To Next Page
Loading...