11
Unpacking and Placement
This section describes the procedures for safely unpacking and placing your
Evolution 202 Preamplifier. The Evolution 202 preamplifier is shipped in 1 carton
consisting of 2 chassis: 1 power supply chassis and 1 preamplifier chassis.
Opening the Evolution 202 Shipping Carton
The Evolution 202 shipping carton measures 22.3 in. (56.6 cm) wide by 23.5 in.
(59.7 cm) high by 16.2 in. (41.1 cm) deep.
Preamplifier Chassis. This measures 17.3 in. (43.8 cm) wide by 3.8 in. (9.7 cm)
high by 18.3 in. (46.4 cm) deep, and weighs 18 lbs. (8.1 kg).
Power Supply Chassis. This measures 17.3 in. (43.8 cm) wide, by 3.8 in. (9.7 cm)
high, by 17.7 in. (44.8 cm) deep, and weighs 28 lbs. (12.7 kg).
To Remove the Preamplifier from the Shipping Carton
1. Open the shipping carton and remove the top layer of foam. The carton con-
tains these items:
1 Preamplifier chassis
1 Power supply chassis
1 IEC Connector (AC Power) cord
1 12-pin DC cable
1 Remote control
2 AAA-size 1.5 Volt batteries for the remote
1 T-10 Torx wrench for the remote control
1 Owner’s Reference
2. Carefully remove the preamplifier, power supply, and accessories from the box.
3. Place the pr
eamplifier and power supply in a safe location, and r
emove the
protective plastic wrapping.
4. Place the power supply chassis where you intend to use the preamplifier.
Kr
ell r
ecommends that you place the pr
eamplifier chassis on top of the power
supply chassis
.
SECTIONTWO
continue
d
To Next Page
Loading...
