Kroeplin C - Series - Page 36

36
Adjusting upper tolerance limit (10,10mm)
2x short
Selecting the relevant digit
1x short
Increasing the digit
1x long
For confirming and saving
Afterwards you will return to the SETUP - Menu.
2x short
Quitting the SETUP – Menu
1x long
For confirming and saving.
The instrument returns to the last program used
„ERR 06“ in the display could be caused by the following:
 Tolerance limit is out of the acceptable range
 The lower tolerance limit is above the upper tolerance limit.
 The upper tolerance limit is below the lower tolerance limit.
Program: TOL