Krone Comprima F 125-1 - Adjusting the Deflection Roller

Maintenance
201
Pos: 47.96.7 /Überschr iften/Überschr iften 3/U-Z/Umlenkro lle versetzen @ 218\mod_13 90928585702_78.doc x @ 1769495 @ 3 @ 1
11.18.1 Adjusting the deflection roller
Pos: 47.96.8 /BA/W artung/Rundballenpress e/Umlenkrolle ver setzen/Umlenkro lle versetzen_Vorausse tzungen @ 215\mod_13908 11158175_78.doc x @ 1760609 @ @ 1
Prerequisites
– The left side protector is raised.
– The left plastic protector is detached.
Pos: 47.96.9 /BA/W artung/Rundballenpress e/Umlenkrolle ver setzen/Umlenkro lle versetzen_Bild @ 215\ mod_1390813804816_78. docx @ 1761351 @ @ 1
VPN00616
1
2
3
a
b
Fig. 172
Pos: 47.96.10 /BA/W artung/Rundballenpres se/Umlenkrolle versetzen/Umlenkrol le versetzen_Text @ 237\ mod_1394637069965_78. docx @ 1879416 @ @ 1
• Dismount scraper (1).
• Remove the threaded pin from the adjusting ring on the deflection pulley (2) and remove the
adjusting ring.
• Dismount deflection shaft (2) and mount with deflection shaft (3) in position (a).
• Push the adjusting ring onto the deflection shaft (2) and secure with threaded pin.
• Mount scraper (1) at a higher position.
• Check whether the tensioning rocker still touches the belt (brush marks). Move scraper and
deflection pulley up into hole (b), if necessary.
Pos: 47.96.11 /BA/W artung/Rundballenpres se/Umlenkrolle versetzen/Hinweis: Umlenkrolle nur 1 Loch höher montieren @ 215\mod_1390 814073967_78.doc x @ 1761437 @ @ 1
Note
Only mount the deflection roller (3) 1 hole higher as otherwise the belt is unnecessary loaded.
Pos: 47.97 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1