Krone Comprima F 125-1 - Direction Information; Term Machine; Figures; Scope of Document

To this Document
9
Pos: 6.9.5 /BA/Zu diese m Dokument/Richtungs angaben_mit Überschr ift 3. Ebene @ 311\mod_1418209 262291_78.doc x @ 2405467 @ 3 @ 1
2.5.2 Direction Information
Direction information in this document such as front, rear, right and left always applies in the
direction of travel.
Pos: 6.9.6 /Überschr iften/Überschr iften 3/A-E/B/Begr iff "Maschine" @ 337\mod_14307 21887716_78.doc x @ 2563575 @ 3 @ 1
2.5.3 Term “Machine”
Pos: 6.9.7 /BA/Zu diese m Dokument/Begrif f Maschine_Rundballenpr essen @ 337\mod_1430721 998881_78.doc x @ 2563610 @ @ 1
Throughout the rest of this document, the “round baler” will also be referred to as the “machine”.
Pos: 6.9.8 /Überschr iften/Überschr iften 3/A-E/A/Abbi ldungen_Darstellungs mittel @ 336\mod_1430133 919063_78.doc x @ 2558462 @ 3 @ 1
2.5.4 Figures
Pos: 6.9.9 /BA/Zu diese m Dokument/Abbildung en_Text @ 336\mod_143013 4111209_78.docx @ 2558 493 @ @ 1
The figures in this document do not always represent the exact machine type. The information
which refers to the figure always corresponds to the machine type of this document.
Pos: 6.9.10 /Überschr iften/Überschr iften 3/U-ZUmfang des Doku ments @ 346\mod_1434979896 995_78.docx @ 2611366 @ 3 @ 1
2.5.5 Scope of Document
Pos: 6.9.11 /BA/Zu diese m Dokument/Umfang des Do kuments_alle Beipac ks und Varianten enthal ten_Text @ 346\mod_1434 979460226_78.doc x @ 2611335 @ @ 1
In addition to standard equipment, accessories kits and versions of the machine are described
in this document. Your machine may deviate from this document.
Pos: 6.9.12 /Überschr iften/Überschr iften 3/A-E/D/Dar stellungsmittel @ 336\mo d_1429865448625_78.doc x @ 2556625 @ 3 @ 1
2.5.6 Means of representation
Pos: 6.9.13 /Überschr iften/Zwischenüb erschriften/P- T/Symbole im Text @ 336\mod_143 0121354111_78.doc x @ 2557539 @ @ 1
Icons in the text
Pos: 6.9.14 /BA/Zu diese m Dokument/Darstel lungsmittel_ohne Hinweis und Warnung_BA @ 339\ mod_1431002650179_78. docx @ 2570965 @ @ 1
In this document, the following means of representation are used:
Action step
A bullet point () designates an action step you have to perform, as for example:
• Set the left outside mirror.
Sequence of actions
Several bullet points () located in front of a sequence of action steps identify a sequence of
actions to be performed step by step, as for example:
• Loosen counter nut.
• Set the screw.
• Tighten counter nut.
List
Dashes (-) identify lists such as, for example:
– Brakes
– Steering
– Lighting
Pos: 6.9.15 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1