Table of Contents
5
8.2.1 Putting Wheels Chocks Underneath ....................................................................................... 103
8.2.2 Moving Parking Support into Support Position ....................................................................... 104
8.2.3 Disconnecting the PTO shaft from the tractor ......................................................................... 104
8.2.4 Disconnecting the supply lines ................................................................................................ 104
8.3 Preparing the machine for transportation ....................................................................................... 105
8.3.1 Raising the Machine................................................................................................................ 105
8.3.2 Securing the side hoods ......................................................................................................... 106
8.3.3 Securing the twine box flap ..................................................................................................... 106
8.3.4 Mounting Transport Tensioning Device .................................................................................. 107
9 Operation ............................................................................................................................................. 108
9.1 Adjustments Before Starting Work ................................................................................................. 108
9.2 Travelling speed ............................................................................................................................. 109
9.3 Filling the bale chamber ................................................................................................................. 110
9.3.1 Reducing the Pressure on the Side Walls of the Bale Chamber ............................................ 111
9.3.2 Mounting additional driver guide rails on the starter roller ...................................................... 112
9.3.3 Mounting additional deflector sheets in the tailgate ................................................................ 113
9.4 Wrapping and Depositing Bales ..................................................................................................... 115
9.5 Driving with Bale Ejector ................................................................................................................ 116
9.6 Before Baling .................................................................................................................................. 117
9.6.1 Tensioning the floor conveyor ................................................................................................. 117
9.7 After Baling ..................................................................................................................................... 118
9.8 Overload protection ........................................................................................................................ 118
9.8.1 Drive Chain for Pick-up with Cam-type Clutch ........................................................................ 118
9.9 Pick-up ........................................................................................................................................... 119
9.9.1 Adjusting the working height ................................................................................................... 119
9.9.2 Adjusting the pick-up height more precisely ........................................................................... 120
9.9.3 Adjusting the bearing pressure relief for the pick-up .............................................................. 121
9.10 Setting the crop press roller unit .................................................................................................... 122
9.11 Setting the baffle sheet .................................................................................................................. 123
9.12 Cutting system ................................................................................................................................ 124
9.12.1 General Aspects ...................................................................................................................... 124
9.12.2 Cutting length .......................................................................................................................... 125
9.13 Setting Bale Diameter .................................................................................................................... 128
9.14 Setting Baling Pressure .................................................................................................................. 129
9.15 Net Wrapping ................................................................................................................................. 130
9.15.1 Net wrapping parts .................................................................................................................. 131
9.15.2 Function of the Net Tying ........................................................................................................ 131
9.15.3 Inserting Net Roll ..................................................................................................................... 132
9.15.4 Insert Net ................................................................................................................................. 133
9.15.5 Adjusting the feed, cut-off and tying position .......................................................................... 135
9.15.6 Setting the Number of Net Layers ........................................................................................... 135
9.15.7 Checking Retaining Comb for Net Tying................................................................................. 136
9.16 Film Tying (for Version with Net Tying and Film Tying) ................................................................. 137
9.16.1 Notes on Operation ................................................................................................................. 137
9.16.2 Removing Paint Residues and Welding Residues Before Start-up ........................................ 138
9.16.3 Inserting Film ........................................................................................................................... 139
9.16.4 Checking the Stretching of the Inserted Film .......................................................................... 143
9.16.5 Setting the Retaining Comb in Case of Film Tying ................................................................. 144
9.16.6 Checking Retaining Comb for Film Tying ............................................................................... 146
To Next Page
Loading...
