Krone LOAD CARRIER - Using the Multi Wall System

LOADING AND SECURING
Operating instructions • Load Carrier • 505410638-02 • 07/2019
101
Multi Block Paper
1
2
Fig.8-14: Multi Block Paper system
1 Multi Block beams
2 Paper wedge receptacle
► Lock the paper wedge in the paper
wedge holder.
► Fasten the paper wedge holder to the
Multi Block beam.
► Fasten the Multi Block system to the
Multilock external frame.
► Tighten the bolts on the paper wedge.
ü The Multi Block Paper system is in-
stalled.
8.7.6 Using the Multi Wall system
KRONE trailers can be equipped with the
Multi Wall load securing system. The Multi
Wall system can be used as a load com-
partment partition transverse to the direc-
tion of travel. The Multi Wall system can
support a surface load of up to 8,000 daN.
1 2
3
4
Fig.8-15: Multi Wall
1 Multi Wall transverse beam
2 Multi Wall support
3 Multi Block beams
4 Plug-in brackets with square tubes
The Multi Wall system prevents the load
from sliding in the direction of travel. It can
be fastened to the Multilock external frame
(see "8.7.1 Using the Multi-Lock external frame",
pg.97).
Inserting the Multi Wall system
► Insert the Multi Block system (see "8.7.5
Using the Multi Block system", pg.99).
► Remove the Multi Wall supports and
the Multi Wall transverse beam from
the storage box (see "5.16 Storage box",
pg.51).