i
1. Introduction ......................................................................................... 1
2. Getting Started .................................................................................... 1
2.1 Unpacking and Inspection ............................................................ 1
2.2 Equipment Checklist ..................................................................... 1
2.3 Printer Parts ................................................................................... 3
3. Setup .................................................................................................... 4
3.1 Setting Up the Printer ................................................................... 4
3.2 Loading the Ribbon ....................................................................... 4
3.3 Loading Label Stock ..................................................................... 6
3.4 External Label Roll Mount Installation (Option) ......................... 8
3.5 Peel-off Module Installation (Option) ......................................... 10
3.5.1 Loading the Paper in Peel-off Mode .................................... 13
3.6 Cutter Module Installation (Option) ........................................... 15
3.6.1 Loading Label in Cutter Mode ............................................. 17
3.7 Instructions to Top Cover Operation ......................................... 18
3.8 Diagnostic Tool ........................................................................... 21
3.8.1 Start the Diagnostic Tool ...................................................... 21
3.8.2 Printer Function (Calibrate sensor, Ethernet setup, RTC
setup………) ................................................................................... 22
3.9 Setting Ethernet by Diagnostic Utility (Option) ........................ 23
3.9.1 Using USB interface to setup Ethernet interface ............... 23
3.9.2 Using RS-232 interface to setup Ethernet interface .......... 24
3.9.3 Using Ethernet interface to setup Ethernet interface ........ 25
3.10 Install Memory Card .................................................................. 27
4. Power on Utilities .............................................................................. 29
4.1 Ribbon and Gap/Black Mark Sensor Calibration ...................... 29
4.2 Gap/Black Mark Calibration；
；；
；Self-test；
；；
；Dump Mode .............. 30
4.3 Printer Initialization ..................................................................... 33
4.4 Black Mark Sensor Calibration .................................................. 34
4.5 Gap Sensor Calibration .............................................................. 34
4.6 Skip AUTO.BAS ........................................................................... 34
5. Maintenance ...................................................................................... 36
5.1 Cleaning ....................................................................................... 36
6. Troubleshooting ................................................................................ 38
6.1 LED Status ................................................................................... 38
6.2 Print Quality ................................................................................. 39
Contents
To Next Page
Loading...