To Next Page

To Previous Page

3.8.2 Printer Function (Calibrate sensor, Ethernet setup, RTC setup………)

1. Select the PC interface connected with bar code printer.

2. Click the “Function” button to setting.

3. The detail functions in the Printer Function Group are listed as below.

Function Description

Calibrate Sensor

Calibrate the sensor specified in the Printer Setup

group media sensor field

Ethernet Setup

Setup the IP address, subnet mask, gateway for

the on board Ethernet (Please refer to next section)

RTC Time Synchronize printer Real Time Clock with PC

Print Test Page Print a test page

Reset Printer Reboot printer

Factory Default

Initialize the printer and restore the settings to

factory default.

Dump Text To activate the printer dump mode.

Ignore AUTO.BAS Ignore the downloaded AUTO.BAS program

Configuration Page

Print printer configuration

Note:

For more information about Diagnostic Tool, please refer to the diagnostic utility quick start

guide in the CD disk \ Utilities directory.

Kroy K4452 User Manual

Questions and Answers: