5756
The gasket seal should be changed
every three years at an Approved Service
Centre.
• The inner lid is missing or not tight enough.
Ensure that the central nut under the
metal lid is tight enough.
• The locking rod is dirty or the seal is missing.
Clean the locking rod according to the
instructions.
The locking rod must be able to move up
and down properly
Ensure that the seal is correctly
positioned on the locking rod.
• The decompression ball is dirty or
incorrectly positioned.
Ensure that the ball is correctly
positioned and that the ball cover is in
the locked position.
Clean and dry the ball
and the support.
• The edge of the bowl is damaged
or dirty.
Clean the bowl.
Ensure that the bowl is in good
condition.
The Cook4me Touch does
not decompress:
• The ball cover is out of place:
Leave the Cook4me Touch to cool
down completely, remove the metal lid,
and place the ball cover in the correct
position.
Water is leaking behind the
Cook4me Touch:
• The collector is not in place or is overowing.
Ensure that the collector is correctly
positioned behind the COOK4ME
TOUCH.
• The bowl is too full.
Ensure that the contents do not exceed
the maximum volume.
• If you are using certain ingredients such as:
- cream,
- wine,
- or milk,
Respect the quantities shown
in the recipe.
These ingredients can cause the
Cook4me Touch to overow
The lid won't open when steam
is released:
• The locking rod is still in the upwards position.
Check that all of the steam
has been released and wait until the
Cook4me Touch has cooled down fully.
The light on the lid handle no
longer lights up:
• The LED is not working.
Take the device to an Approved Service
Centre.
The screen does not light up:
• The COOK4ME TOUCH is not plugged in.
Ensure that the COOK4ME TOUCH is
plugged in correctly.
• The Cook4me Touch is on standby.
Press the dot on the screen.
To Next Page
Loading...
Need help?
General
