KRUPS SERIE EA9000
24
Caution: Caution: Do not place your hand or any other obstacle in front of the nozzle that can hinder
the movement of the nozzle.
Caution: If you do not set a cup in place or if you do so incorrectly, there may be risks of
pinching or scalding.
If you press the Stop button, the entire recipe is stopped, and therefore the brewing will be
cancelled. The unused ground coffee will then be ejected.
!
4
n Place the cup under the coffee nozzles.
n The cup must be placed close to the cleaning container, under the steam
nozzle, at the back of the niche.
n However, do not press the cleaning container (11) with the cup; otherwise,
it might break off.
n You can lower or raise the coffee nozzle to suit the size of your cup. The
steam nozzle will descend just behind the coffee nozzles. Caution: the
maximum height of the cup is defined by the coffee nozzles; do not tilt the
cup to place it under the coffee nozzles.
n To use a large cup (or mug), you might have to remove the small drip tray (6).
n Press the “OK” button.
5
n Milk preheating phase: The milk is first preheated and during this
time the beans are ground for preparing the coffee.
n The nozzle moves forward and goes down into the milk
n The nozzle tip must be submerged in the milk by 1 cm for perfect results.
If this is not the case, the cup is not suitable for the volume chosen; stop
the preparation using the “Stop” button and change the cup.
n If the milk used is at an initial temperature higher than 7°C, you can
shorten the preheating time by pressing “>>” and move on to frothing to
avoid “spoiling” the recipe.
To Next Page
Loading...
Need help?
General
