RDL
2
0. Introduction
KSB has supplied you an equipment that has been designed and manufactured with the latest technology.
Due to its simple and tough construction, it will need little maintenance. With the aim to provide our clients with satisfactory,
trouble free operation, we recommend to install and maintain our equipment according to the instructions contained in this
service manual.
This manual has been prepared to inform the end user about construction and operation of our pumps, describing the proper
procedures for handling and maintenance.
We recommend that this manual should be handed over to the maintenance supervision.
The equipment must be used at operation conditions for which it has been selected, such as: flow rate, total head, speed,
voltage, frequency and temperature of pumped liquid.
For requests about the equipment, or when ordering spare parts, please mention the type of pump
and the Production Order number. This information can be obtained from the nameplate of each
pump. If the nameplate is not available, the OP number is stamped in low relief on the suction
flange and on the discharge flange you may find the impeller diameter.
This instruction manual contains very important recommendations and instructions. Must be
carefully read before installation, electrical connection, first start up and maintenance.
Fig.1 – Nameplate
size of the pump
(serial number - OP)
of manufacturer data
ATTENTION:
To Next Page
Loading...
