KTM 1190 RC8 EU 2008 - SET‑UP; Unpacking and setting up the vehicle

SET‑UP 3
2SET‑UP
2.1Unpacking and setting up the vehicle
– Remove the cardboard packing material.
700354-01
– Remove the adhesive tape at the top of the motorcycle.
700355-01
– Roll down the plastic sheeting on the sides.
Info
To avoid damaging the motorcycle while unpacking it, leave the remaining
plastic sheeting on the motorcycle until you have finished.
– Remove the separate enclosure from the seat.
– Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
– Check the vehicle for transport damage.
700356-01
– Remove plastic  from the handlebar stubs.
– Remove screw  with distance sleeve  from both handlebar stubs.
– Adjust the handlebar height. ( p. 5)
Info
Mount the handlebar stubs in the low position.
700357-01
– Remove the side screws  on the left holder.
– Remove the top screws  on the left holder.
– Loosen the holder from the base frame in an upward direction.
700358-01
– Remove the side screws  on the right holder.
– Remove the top screws  on the right holder.
– Leave the holder on the base frame.
Info
The motorcycle is leaning toward the right and is resting against the holder
on the base frame.