KTM 1290 Super Duke GT Series User Manual

2 SETUP 5
E00282-10
(1290 Super Duke GT US)
– Bond the reflectors on the right and left side of the reflector holder.
–
Mount the reflector holder on license plate holder

.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
E00273-01
– Remove the passenger seat. ( p. 7)
– Remove spare key and KEYCODECARD and keep in a safe place for the handover.
– Secure the tool set with the rubber holder.
E00274-01
– Carefully loosen and remove the tension belt from the frame.
Info
An assistant prevents the motorcycle from falling over.
– Carefully loosen and remove the tension belts around the fork legs.
The vehicle is released at the front.
– Together with an assistant, take the vehicle off the palette.
– Remove the radiator shield.
S01188-10
–
Position the front spoiler. Mount and tighten screws

with the washers.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
S01189-10
–
Position metal sheets on the left and right. Mount and tighten screws

.
Guideline
Remaining screws, chassis M5 5 Nm (3.7 lbf ft)
E00280-10
– Remove the front rider's seat. ( p. 7)
–
Plug in the connector of starter relay

.
(1290 Super Duke GT US)
– Mount the side cases.
Info
Observe the accompanying fitting instructions.
– Recharge the battery. ( p. 8)
– Remove the protective plastic.
– Refuel. ( p. 10)

KTM 1290 Super Duke GT Series Specifications

General

Displacement	1301 cc
Transmission	6-speed
Bore x Stroke	108 mm x 71 mm
Front Tire	120/70 ZR17
Rear Tire	190/55 ZR17
Torque	140 Nm @ 8000 rpm
Fuel Capacity	23 liters
Seat Height	835 mm
Cooling System	Liquid Cooled
Front Suspension	WP USD Ø 48 mm
Rear Suspension	WP monoshock
Front Brake	Dual 320 mm discs, 4-piston calipers
Rear Brake	Single 240 mm disc, 2-piston caliper
Traction Control	MTC (Motorcycle Traction Control)
Frame	Chromoly steel trellis frame, powder coated
Dry Weight	205 kg
Wheelbase	1482 mm