22 TROUBLESHOOTING 169
Faults Possible cause Action
The combination instrument shows
nothing on the display
Fuse 1 is blown – Change the fuses in the fuse box. ( p. 138)
The main fuse is blown – Change the main fuse. ( p. 135)
The battery is discharged –
Recharge the battery. x ( p. 131)
–
Check the open-circuit current. x
The ignition/steering lock is faulty –
Check the ignition/steering lock. x
The engine does not crank when the
electric starter button is pressed
The emergency OFF switch is off – Press the emergency OFF switch to the posi-
tion ON .
Operating error – Carry out the start procedure. ( p. 67)
The battery is discharged –
Recharge the battery. x ( p. 131)
–
Check the open-circuit current. x
The safety start system is faulty – Read out the fault memory using the KTM diag-
nostics tool. x
CAN bus communication error – Read out the fault memory using the KTM diag-
nostics tool. x
Fault in EFI control unit. – Read out the fault memory using the KTM diag-
nostics tool. x
Fault in the MCU control unit. – Read out the fault memory using the KTM diag-
nostics tool. x
The engine only turns if the clutch
lever is drawn
The vehicle is in gear – Shift the transmission to idle .
The safety start system is faulty – Read out the fault memory using the KTM diag-
nostics tool. x
The engine turns although a gear is
engaged
The safety start system is faulty – Read out the fault memory using the KTM diag-
nostics tool. x
The engine turns but does not start The coupling of the fuel hose connec-
tion is not connected
– Reconnect the coupling of the fuel hose connec-
tion.
To Next Page
Loading...
