KTM 620 - Page 18

ENGLISH
16
TOTAL MILEAGE „DST“
TIME „CLK“
after changing battery
1 sec
5 sec
1 sec
1. use the right button to select
the position to be changed
1. make sure the time is indicated
and push the button on the
back approx. 5 seconds (time
starts blinking)
2. push the left button until the right
figure is showed in the display
3. by pushing the right button you
jump to the next figure
4. repeat nos. 2 + 3 until correct time is indicated
5. push the button on
the back approx. 1
second to terminate
the setting procedure
2. push the left button until the right
figure is showed in the display
3. by pushing the right button
you jump to the next figure
4. repeat nos. 2 + 3 until the previously
noted total mileage is indicated
5. push the button on the back
with a sharp object approx. 1
second to terminate the set-
ting procedure (the value is
thus stored)