CLEANING, CARE 17
109
Info
The heat produced causes water at inaccessible loca-
tions in the engine and on the brake system to evapo-
rate.
– Push back the protection caps on the handlebar controls to
allow water to evaporate.
– After the motorcycle has cooled down, lubricate all moving
parts and pivot points.
– Clean the chain. ( p. 62)
– Treat bare metal (except for brake discs and the exhaust sys-
tem) with a corrosion inhibitor.
Preserving materials for paints, metal and rubber
( p. 124)
– Treat all plastic parts and powder-coated parts with a mild
cleaning and care product.
Special cleaner for glossy and matte paint finishes, metal
and plastic surfaces ( p. 125)
To Next Page
Loading...
