KTM 85 SX 2021 - Removing the Shock Absorber

11 SERVICE WORK ON THE CHASSIS
54
11.16 Removing front fender
Preparatory work
– Remove the start number plate. ( p. 53)
V00830-10
Main work
–
Remove screws
1
.
–
Remove screws
2
. Take off the front fender.
11.17 Installing front fender
V00831-10
Main work
– Position front fender.
–
Mount and tighten screws
1
.
Guideline
Screw, front fender M6 6 Nm (4.4 lbf ft)
–
Mount and tighten screws
2
.
Guideline
Screw, front fender M6 6 Nm (4.4 lbf ft)
Finishing work
– Install the start number plate. ( p. 53)
11.18 Removing the shock absorber
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 44)
A00044-10
Main work
– Detach the brake line from the brake line guide.
–
Remove screw
1
and lower the rear wheel with the link fork
as far as possible without blocking the rear wheel. Secure the
rear wheel in this position.
–
Remove screw
2
, push splash protector
3
to the side, and
remove the shock absorber.