2 SETUP
10
– Tighten all the screws of the right footrest bracket with the
passenger footrest.
Guideline
Screw, footrest
bracket, rear
M8x40 25 Nm (18.4 lbf ft)
Loctite
®
243™
Screw, footrest
bracket, rear
M8x25 25 Nm (18.4 lbf ft)
Loctite
®
243™
Remaining
screws, chassis
M8 25 Nm (18.4 lbf ft)
– Carefully loosen and remove the rear tension belt.
Info
An assistant prevents the motorcycle from falling over.
– Carefully loosen and remove the tension belts around the fork
legs.
The vehicle is released at the front.
– Together with an assistant, take the vehicle off the pallet.
– Remove the passenger seat. ( p. 12)
– Remove the spare key and KEYCODECARD keep in a safe place
for the handover.
Warning
Risk of injury Battery acid and battery gases cause
serious chemical burns.
– Keep 12 V batteries out of the reach of children.
– Wear suitable protective clothing and safety
glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the 12 V
battery.
– Only charge 12 V batteries in well-ventilated
rooms.
– Rinse the affected area immediately with plenty of
water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and
consult a doctor immediately if battery acid and
battery gases get into the eyes.
– Fill the 12 V battery.
Info
Read the notes in the 12 V battery accessory pack.
– Charge the 12-V battery. ( p. 13)
Guideline
The 12-V battery must be fully charged before it is handed
over to the customer.
To Next Page
Loading...
