13 WHEELS, TIRES 126
B01368-11
– Mount the wheel spindle but do not push it in all the way.
– Push the rear wheel as far forward as possible and place the chain on the rear sprocket.
– Push the wheel spindle in all the way and mount chain adjuster 3 and nut 4.
Info
Mount chain adjuster 2 and 3 in the same position.
– Push the rear wheel forward so that the chain adjusters are in contact with the adjust-
ing screws, and tighten nut 4.
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks B.
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
Thread greased
– Operate the foot brake lever repeatedly until the brake linings lie on the brake disc and
there is a pressure point.
Finishing work
– Raise the vehicle off of the center stand. ( p. 87)
13.5 Checking the rear hub rubber dampers x
Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. They eventually wear out during
operation. If the rubber dampers are not changed in time, the rear sprocket carrier and the rear hub will be damaged.
To Next Page
Loading...
Need help?
General
