2 SETUP 3
2.1 Unpacking and setting up the vehicle
S00827-01
– Remove straps and box.
S00828-01
– Remove the adhesive tape in the upper area of the motorcycle.
S00829-01
– Roll down the film at the sides.
Info
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
– Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
– Check the vehicle for transport damage.
S00825-10
–
Position damping rubber
on both sides.
–
Join plug-in connector
of the mirror on both sides.
– Position the rear mirror on both sides. Mount and tighten the screws.
– Position all controls in their exact positions on the handlebar. Tighten all screws.
S00826-01
– Mount the reflector.
– Remove the protective plastic.
– Carefully loosen and remove the tension belt over the swingarm.
Info
An assistant prevents the motorcycle from falling over.
– Carefully loosen and remove the tension belts around the lower triple clamp.
The vehicle is released at the front.
– Take the vehicle off the pallet.
To Next Page
Loading...
Need help?
General
