KTM Supermoto 690 User Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE 79
100176-10
ದ Stand the vehicle upright.
ದ Remove screw coverb
 with membraneb.
ದ Top up the brake fluid tobMAX level.
Brake fluid DOT 5.1 ( P. 152)
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Refit screw with membrane.
Info
Clean up overflowed or spilt brake fluid immediately with water.
Checking rear brake linings
Warning
Danger of accidentsಘReduced braking due to worn brake linings.
ದ Worn brake linings should be replaced immediately in an authorized KTM workshop.
Note
Danger of accidentsಘReduced braking due to damaged brake discs.
ದ If the brake linings are not changed in time, the steel brake lining carriers grind on the brake disc. The braking effect is greatly re-
duced and the brake discs are destroyed.

KTM Supermoto 690 Specifications

General

Compression Ratio	12.7:1
Transmission	6-speed
Engine Type	Single cylinder, 4-stroke
Power Output	74 hp (55 kW) @ 8000 rpm
Torque	73.5 Nm @ 6, 500 rpm
Starter	Electric
Rear Suspension	WP monoshock
Front Brake	320 mm disc, 4-piston caliper
Rear Brake	240 mm disc, single-piston caliper
Front Wheel	17 inch
Rear Wheel	17 inch
Seat Height	890 mm
Fuel Tank Capacity	13.5 l
Fuel System	Electronic fuel injection
Frame	Chrome-molybdenum trellis frame, powder coated