3. Place the speed-set-rod in the off position.
(1) Speed set rod
(A) On
(B) Off
4. Place the speed-control-pedal in the neutral
position.
(1) Speed control pedal
NOTE :
• The speed-control-pedal automatically
returns to the neutral position when the
operator's foot is released from the speed-
control-pedal.
5. Place the range-gear-shift-lever (Hi-Lo) in the
neutral [N] position.
(1) Range gear shift lever (Hi-
Lo)
(A) Low
(B) Neutral
(C) High
6. Place the lock lever in the lock position to lock
the auxiliary-hydraulic-control-lever if the tractor is
equipped with the auxiliary-hydraulic-control-lever.
(1) Auxiliary hydraulic control
lever
(2) Lock lever
(A) Lock
OPERATING THE ENGINE STARTING THE ENGINE
To Next Page
