ENGINE
EA330-E4, WSM
1-S39
Flywheel
1. Set a flywheel puller (Code No. 17916-04052) and remove it
with the flywheel.
• Clean the flywheel and crankshaft tapered section to be
free from any dirt or chips. Also take care so that oil does
not stick to the crankshaft tapered section.
9Y1211018ENS0058US0
Crankshaft and Main Bearing Case
1. Remove the flywheel key.
2. Remove the bolts of main bearing case.
3. Insert the tip of a screwdriver in the gap "A" between the
bearing case and the cylinder block (as shown with in the
photo). Then, by prying the screwdriver to left and right evenly,
pull out the bearing and the crank shaft together.
(When reassembling)
• Check that the O-ring is not damaged and apply a light coating
of oil to the ring.
• Tighten the main bearing case retaining bolts gradually in the
order of (a) to (i) as shown in the figure.
9Y1211018ENS0059US0
Tightening torque
Main bearing case
mounting screw / nut
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
A: Gap
To Next Page
Loading...
