Kubota EA330-E4 Series - Page 123

ENGINE
EA330-E4, WSM
1-S58
Camshaft Alignment
1. Support the camshaft with V block on the surface plate and set
a dial indicator with its tip on the intermediate journal at right
angle.
2. Rotate the camshaft on the V block and get the misalignment
(half of the measurement).
3. If the misalignment exceeds the allowable limit, replace the
camshaft.
9Y1211018ENS0103US0
Camshaft alignment Allowable limit
0.08 mm
0.003 in.
KiSC issued 05, 2015 A