Kubota WSM OC95-E2 - Check Point of Initial 25 Hours; Check Points of Every 100 Hours

OC60-E2, OC95-E2, WSM GENERAL
G-7
[2] CHECK POINT OF INITIAL 25 HOURS
Changing Engine Oil and Cleaning Oil Strainer
1. After warming up the engine, remove the drain plug (1) and
drain the oil completely.
2. Put the drain plug and supply the specified quantity of the
specified oil through the oil inlet.
A Clean the oil strainer (2) each time oil is changed.
(When cleaning oil strainer)
1. Clean the oil strainer with fuel oil.
2. If the oil strainer is deformed or broken, replace it.
[3] CHECK POINTS OF EVERY 100 HOURS
Changing Engine Oil and Cleaning Oil Strainer
1. After warming up the engine, remove the drain plug (1) and
drain the oil completely.
2. Put the drain plug and supply the specified quantity of the
specified oil through the oil inlet.
A Clean the oil strainer (2) each time oil is changed.
(When cleaning oil strainer)
1. Clean the oil strainer with fuel oil.
2. If the oil strainer is deformed or broken, replace it.
(1) Drain Plug (2) Oil Strainer
0000009339E
(1) Drain Plug (2) Oil Strainer
0000009339E