6. - Putting into service
GF8702
43
KN142BGB G
Gyrotedder
If this is not the case:
- Mark length (H) to cut when the transmission is the
maximum overlap position.
- Shorten the guard tubes and the transmission
tubes by the same length.
- Bevel and clean the tubes.
- Grease the inside of the outer tube.
Check that there is still a minimum overlap of
250 mm (10’’) when the machine is in working
position and the tractor in line with the machine.
- Never operate the PTO shaft at an angle X
exceeding 30°.
To Next Page
