KUHN GF8702 - Identification of the Machine; Front View (Transport Position); Front View (Working Position)

92 pages

Save Page as PDF

To Next Page

To Previous Page

3. - Identification of the machine

GF8702

KN142BGB G

Gyrotedder

3. Identification of the machine

3.1 Front view (transport position)

3.2 Front view (working position)

Main Page

Dear Owner3
Table of Contents4
Contents4
Identification of the Machine7
Front View (Transport Position)7
Front View (Working Position)7
Model Identification Plate8
Optional Equipment9
Safety10
Description of Symbols Used in this Document10
Safety Instructions11
Introduction11
Precautions to be Taken before Carrying out any Operations on the Machine11
Read and Follow the Safety Instructions12
Precautions to Take before Using the Machine12
Precautions When Driving13
Precautions When Driving on Public Roads13
Maximum Speed17
Precautions When Coupling18
Hydraulic Circuit19
PTO Shaft20
Precautions to Take before Using the Parking Stands22
Precautions During Manoeuvres22
Remote Controlled Components22
Tyres22
Safety Decals23
Waste Disposal23
Precautions for Maintenance and Repair Work24
Projection of Stones and Foreign Objects25
Precautions to Take before Using the Parking Stands25
Precautions for Machine Use26
Likely Critical Failures26
Location and Description of Safety Decals on the Machine27
Location of Safety Decals27
Road Safety Equipment and Recommendations29
Instructions Specific to France31
Tyre Pressure32
Likely Critical Failures32
Incorrect Use of the Machine by the User32
Limit State Criteria33
Machine Specifications34
Description and Glossary34
Technical Specifications35
Designated Parameters35
Required Equipment36
Primary PTO Shaft36
Lighting and Signalling36
Sound Levels37
Putting into Service38
Description of Control Elements38
Coupling and Uncoupling38
Description of Coupling Elements38
Preparing the Tractor39
Preparing the Machine41
Coupling the Machine41
Hydraulic Connections43
Electrical Connection43
Primary PTO Shaft44
Folding/Unfolding Sequence46
Uncoupling the Machine47
Instructions for Transport50
Putting the Machine into Transport Position50
Conformity with the Road Regulations52
Machine Transport Using Transport Means53
Instructions for Work54
Putting the Machine into Work Position54
Adjustments in Working Position55
Pitch Angle Adjustment56
Work in Oblique Position57
Adjustment of the Travel Range for Work on Slopes57
Machine Use59
Drive Speed59
Optional Equipment61
3/8'' - 6 Spline Pto Shaft61
32X38 - 8 Spline Pto Shaft61
DUPLEX Gearbox61
Prop Wheel62
Machine Use62
Putting the Machine into Transport Position62
Putting the Machine into Work Position62
SUPERBALLOON Spare Wheel63
Wide SUPERBALLOON Spare Wheel63
Lower Hitch Pins63
Lateral Signalling Equipment (for France)64
USA Signalling Equipment64
Coupling and Uncoupling64
Maintenance and Storage65
Adjustments in Working Position65
Frequency Chart65
Lubrication66
Pto Shaft67
Grease67
Oil69
Maintenance69
Central Gearbox Oil Level Control69
Checking the Fixing Elements70
Replacing a Tine71
Replacing a Synchronized Unfolding Cable73
Tyre Pressure77
Storage78
At the End of each Season78
At the Start of each Season79
Storage79
Dismantling and Scrapping of the Machine80
Appendix81
Calculating the Load on an Axle81
Limited Warranty89

KUHN GF8702 - Identification of the Machine; Front View (Transport Position); Front View (Working Position)

Table of Contents

Related product manuals