From the transport position:
Place a container of sufficient capacity under drain plug.
Remove filler plug (1) and its washer.
Remove drain plug (2) and its washer.
Allow oil to drain completely.
Wait for dripping to stop.
Clean and reinstall drain plug (2) and its washer.
Replace if necessary.
Pour the correct oil quantity and quality through the
opening of the filler plug.
The oil must reach the lower edge of the filling hole.
Clean and reinstall filler plug (1) and its washer. Replace
if necessary.
When draining and refilling, it is recommended to use either a mineral base oil with viscosity grade SAE80W90 and API
grade GL5, or a synthetic base oil, type PAO (Poly
-
Alpha
-
Olefins) with a viscosity grade equivalent to SAE80W90.
To Next Page
Loading...
