KUHN GMD44 - Cutterbar Draining and Refilling Procedure

GMD44 _760001 _xxxxxx
Cutterbar draining and refilling
Required equipment
Preliminary operations
Operating procedure
Main operations
Never use an oil of viscosity SAE90 in the cutterbar.
Before draining oil, operate the machine for a few
minutes so that the oil warms up.
Step 1.
The cutterbar is lubricated with 1.750.46 of extreme - pressure gear oil with viscosity grade SHELL SPIRAX A and
SAE80W90 grade API.
1
30 min
8
Page 19/95Printing date : 06-02-2014 GMD44_760001_xxxxxx
©Copyright KUHN S.A.