Power harrow
54
HR6004DR
Optional equipment
Stroke limiters:
- Couple up the PTO shaft (between the power harrow
and the additional machine).
- Lift the combined machine using the rear hydraulic lift
linkage:
• When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against
the yokes. As a safety measure, a clearance (L) of
at least 25 mm (1’’) must be maintained.
- Tighten the assembly using nut (1).
Machine use
By fitting the hydraulic attachment stroke limiters, the
additional machine can be raised by 600 to 700 mm
(23.6’’ - 27.5’’) while folding the half-harrows.
By removing the stroke limiters, the additional machine
can be fully raised.
This part has several functions:
- Avoid any interference between the
machine components during half-
harrow folding manoeuvres and when
raising the additional machine.
- Protect the PTO shaft in case of driven
combinations.
If the power harrow is used with an additional
PTO driven machine, make sure to uncouple
PTO shaft before fully raising the additional
machine.
To Next Page
Loading...