Service Manual EKI 21
For internal use only
Fault messages
Fault code Description Comments
E-00 Reset Control is initialising itself again.
Automatic process after voltage supplied (not a
fault).
E-13 EEPROM does not receive any
valid data.
EEPROM not equipped.
EEPROM not programmed.
Comparative parameters not OK.
E-22 Touch control defective. Button bank always provides the same A/D
value.
E-27 Heat sink sensor defective. Sensor breakage, sensor short-circuit.
E-28 Saucepan sensor parameter Transmission to the ASIC not OK.
E-29 Cooking zone assignment Assignment of the actuators to the cooking
zones is not OK (EPROM).
To Next Page
Loading...
