EasyManuals Logo

Kurio Smart User Manual

Kurio Smart
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
24
RF exposure compliance with any body-worn accessory, which contains me-
tal, was not tested and certified, and use such body-worn accessory should be
avoided. This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment.
End user must follow the specific operating instructions for satisfying RF expo-
sure compliance.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to ra-
dio waves established by the Federal Communications Commission (USA). The
SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. This pro-
duct has been tested and complies with this exposure limit. Please refer to the
physical device for applicable FCC ID.
Exposure to Radio Frequency Energy
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encou-
raged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or experienced radio/TV technician for help.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kurio Smart and is the answer not in the manual?

Kurio Smart Specifications

General IconGeneral
BrandKurio
ModelSmart
CategoryTablet
LanguageEnglish

Related product manuals