13-44

Disk Mode

Macros

The following page is what you will see if macro recording is Off:

Func:MACRO||||||[|Off||]|||||Index:|||0|

||||||||||||||||||||||||||||||||||||||||

Select|Modify||Load||Record||On||||Exit|

The top line displays the disk function, the current macro mode, and an index value into the

Macro table.

Func:MACRO||||||[|On|||]|||||Index:|||0||

Macro Modes

The K2600 has three macro modes: Record, Pause, and Off.

Off There is no Macro table in the K2600.

Record A Macro table exists, and the K2600 adds all Þle-loading operations to the Macro

table.

Pause A Macro table exists, but the K2600 does not add Þle-loading operations to it.

Note that whenever macro mode is Off, there are two soft buttons labeled Record and On.

Pressing On will enable Macro Record mode, and then will return to the Disk-mode page. As an

alternative, pressing Record will also enable Macro Record mode, but the display will remain on

the MACRO page. Once you press Record, the soft buttons and the top line of the display will

change. The display will look like this:

Func:MACRO||||||[Record]|||||Index:|||0|

||||||||||||||||||||||||||||||||||||||||

Select|Modify||Load||Pause||||Off||Exit|

The new macro mode is displayed ([Record]), and the soft button that used to say Record now

says Pause. The soft button that used to say On now says Off. Pressing Pause will cause the

macro mode to read [Pause] and the Record soft button will reappear. You can switch between

Record and Pause by pressing this button repeatedly.

Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 13 User Manual

Questions and Answers: