Disk Mode
Disk Utilities
13-63
The Dir Þeld shows the directory that is being listed. The size value displayed on the top line of
the display represents the total size of the directory subtree that is currently being viewed. The
Root, Up, and Down soft buttons navigate through the directory hierarchy:
Root Display the disk from the top level, meaning that all of the Þles on the disk will
appear in the scrollable list.
Down Set the display to the level of the highlighted Þle or directory.
For example, scrolling to TRUMPETS in the above list, and pressing Down, would
focus the list on the contents of the TRUMPETS directory, starting with JSBACH.K26.
Up Set the display up one directory level.
Go To Exit to the Disk-mode page, setting the current directory and Þle index to the location
of the highlighted Þle or directory.
The next disk function you choose will display the current directory with the found
Þle already highlighted. If a directory was found, then the Þrst Þle in the directory list
will be highlighted.
Cancel Exit to the Disk-mode page. The current directory is unchanged.
The Þles are listed in the order that they appear on the disk, unalphabetized. The traversal order
of the directories is the same one that is also used for the Backup function.
Free
The Free utility calculates the amount of free space on the current disk and displays the result on
the Disk Utilities page. This may take a small amount of time to calculate, depending on the
disk.
||||||||||||||||||||||||||||||||||||||||
Computing|free|space|on|SCSI|2||||||||||
||||||||||||||||||||||||||||||||||||||||
Please|wait...||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
DiskUtil:|SCSI|2|||||||(DOS)||||||||||||
Used:23%|||Free:94814K|||Total:124396K||
||||||||||||||||||||||||||||||||||||||||
Select|utility|function:||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||Info|||Find|||List||Free|||Done|
The parameters tell you the following:
Used The percentage of the disk that is taken up by the existing information stored on it.
Free The amount of disk space available for new Þles.
Total The size of the disk. This will be the size of the usable partition if MS-DOS format.
To Next Page
Loading...
Need help?
General
