Kurzweil M110 - Chapter 15 Appendix; Chapter 16 Troubleshooting

28
Troubleshooting
Chapter 16
Problem Cause Solution
No sound is produced when
the keys are played.
1. The master volume is set
in the minimal level.
2. Headphone is connected.
3. Local Control is set to Off.
1. Make sure the volume is
set to an appropriate level.
2. Disconnect the
headphones from the jack.
3. Set Local Control to On.
Sometime the speaker
produce noise
1. A noise neighboring
electrical appliances.
2. A noise neighboring bulbs
or neon signs.
1. Use an another outlet from
the outlet used for the
appliance.
2. Put your instrument far
from the bulbs or the neon
signs.
No sound when an amplier
is connected
1. The master volume is set
in the minimal level.
2. The extension cord is
faulty.
1. Make sure the volume is
set to an appropriate level.
2. Replace it with the new.
Check if one of the following might be the issue.
Please contact us If the problems continue.