41
Any effect in the „Select FX Chain‟ window can also be edited to create your own custom
effects chains. To edit an effects chain, click on the EDIT button. Editing FX Chains is covered
as a separate topic later in this Chapter.
Layers Overview Panel
The Program Common window displays an overview of every Layer (up to 32) that makes up a
Program. The Layers Overview Panel provides basic information about each layer:
The MUTE (red) and SOLO (yellow) buttons in the Layers Overview panel can be used to
mute any of the layers, or solo the current layer. The other controls shown in the Layers
Overview panel are non-functional.
Clicking on a Layers Overview panel will bring up the Layers Edit Window for that Layer, where
all layer parameters can be altered. The Layers Edit Window is covered in the next section.
Right-clicking on any Layers Overview panel produces a contextual menu that allows you to
copy, paste, add, remove and initialize Layers:
In this menu:
The „Copy Layer‟ command copies the currently selected Layer.
The „Paste Layer‟ command pastes a previously copied Layer to the current Layer. This
command only appears in the menu after completing a „Copy Layer‟ operation.
The „Paste - Add Layer‟ command adds a new Layer to the Program and pastes the copied
Layer there.
Selecting the „Paste Layer From‟ and „Import Layer‟ commands produces a drop-down list that
allows you to select a Layer from another Program (see description below).
To Next Page
Loading...
